909 RC1200 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła 909 RC1200. 909 RC1200 12 stron.
Drukuj stronę•
If you are interrupted when operating the saw, complete
the process and switch off before looking up.
Periodically check that all nuts, bolts and other fixings are
•
properly tightened.
•
Always hold the saw on parts that are insulated. If you
accidentally cut into hidden wiring or the saw's own cable,
the metal parts of the saw will become "live".
•
Never saw near combustible liquids or gases.
The tool must be used only for its prescribed purpose
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool's construction
and design:
•
Contact with the blade.
•
Kickback of work piece and parts of work piece.
•
Blade fracture.
Catapulting of blade pieces.
•
•
Damage to hearing if effective earmuffs are not worn.
•
Harmful emissions of sawdust when the machine is
used in closed rooms. Always use supplementary dust
extraction where possible.
•
Do not use blades that are deformed or cracked.
•
Fully unwind cable drum extensions to avoid potential
overheating.
When an extension cable is required, you must ensure
•
that it has the right ampere rating for your power tool and
is in safe electrical condition.
•
After long working periods external metal parts and
accessories could be hot.
•
Do not force the saw; let the tool do the work at a
reasonable speed. Overloading will occur if too much
pressure is applied and the motor slows resulting in
inefficient cutting and possible damage to the motor.
•
Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the blade.
WARNINGS.
Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on the
nameplate of the tool. A power source with a voltage greater
than that specified for the tool can result in serious injury to
the user, as well as damage to the tool. If in doubt, do not
plug in the tool. Using a power source with a voltage less
than the nameplate rating is harmful to the motor.
WARNINGS.
We recommend the use of a residual current
device with a residual current rating of 30mA or less.
Accessories
The 909 RC1200 Reciprocating Saw is supplied in a
storage case with the following accessories:
•
1 x Wood Cutting Blade
•
1 x Metal Cutting Blade
•
Carry Case
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
6