909 20VHTG Instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Trymer 909 20VHTG. 909 20VHTG 16 stron.
Drukuj stronęUsing the hedge trimmer
Safety features
1. The cutting blade is
supplied with a sheath
type cover. Keep the cover
on the blades when ever
the tool is not being used.
2. When the hedge trimmer
is not being used it is
suggested to remove the
battery pack to prevent
unauthorised use of the tool.
3. The rear handle trigger switch (1) and front handle bar
switch (2) must be operated together to start the motor. This
ensures that both hands are used to control the trimmer.
4. If either of the two switches is released, the tool is
designed to stop rapidly.
Switching on and off
1. To switch on, press both
the trigger switch (1) and
the bar switch (2) at the
same time.
2. The bar switch (2) can be
activated from 3 positions;
to the left of the handle, to
the right of the handle, or
pushing on the back of the
handle
2. The bar switch (2) can be activated from 3 positions; to
the left of the handle, to the right of the handle, or to the
top of the handle.
3. To switch off, release either switch..
Safety points during operation.
Wear eye protection when using this tool.
•
•
Always use two hands to hold the tool. One on the rear
handle and one on the front loop handle.
20VHTG IM ed6.indd 13
•
Always ensure good balance. Both feet should be firmly
on the ground.
•
Prior to cutting, check the area to be cut for any hidden
foreign objects. ie fencing wire. These can be hidden in
branches etc and should be removed or care taken when
working close.
Do Not use the hedge trimmer close to ANY electrical wires
Shaping
1. Trim a hedge so that it is
wider at the bottom than
the top.
2. This improves light
penetration and promotes
healthy growth.
3. Narrow the hedge
approximately 100 mm for
every metre in height.
4. A bush can be round or column shaped.
Cutting
1. Assume a secure position,
using two hands to hold the
trimmer and switch on.
2. Trim both sides of the
hedge, starting at the
bottom. This prevents
cuttings falling into the area
yet to be cut.
3. Pass the blade lightly
through the surface of the
hedge. Do not attempt to
cut too deep.
4. Trim the top of the hedge.
5. For older hedges that
require cutting back substantially, use pruning shears to
cut the thicker branches and then finish the job with the
hedge trimmer.
WARNING.
Do not let the blade come into contact with
fencing wire or any other object that could damage it.
13
HT18V
HT18V
28/8/13 8:10:06 AM