909 20VHTG Kullanım Kılavuzu - Sayfa 13

Düzeltici 909 20VHTG için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 20VHTG 16 sayfaları.

Sayfayı Yazdır

Using the hedge trimmer

Safety features

1. The cutting blade is

supplied with a sheath

type cover. Keep the cover

on the blades when ever

the tool is not being used.

2. When the hedge trimmer

is not being used it is

suggested to remove the

battery pack to prevent

unauthorised use of the tool.

3. The rear handle trigger switch (1) and front handle bar

switch (2) must be operated together to start the motor. This

ensures that both hands are used to control the trimmer.

4. If either of the two switches is released, the tool is

designed to stop rapidly.

Switching on and off

1. To switch on, press both

the trigger switch (1) and

the bar switch (2) at the

same time.

2. The bar switch (2) can be

activated from 3 positions;

to the left of the handle, to

the right of the handle, or

pushing on the back of the

handle

2. The bar switch (2) can be activated from 3 positions; to

the left of the handle, to the right of the handle, or to the

top of the handle.

3. To switch off, release either switch..

Safety points during operation.

Wear eye protection when using this tool.

•

Always use two hands to hold the tool. One on the rear

handle and one on the front loop handle.

20VHTG IM ed6.indd 13

•

Always ensure good balance. Both feet should be firmly

on the ground.

•

Prior to cutting, check the area to be cut for any hidden

foreign objects. ie fencing wire. These can be hidden in

branches etc and should be removed or care taken when

working close.

Do Not use the hedge trimmer close to ANY electrical wires

Shaping

1. Trim a hedge so that it is

wider at the bottom than

the top.

2. This improves light

penetration and promotes

healthy growth.

3. Narrow the hedge

approximately 100 mm for

every metre in height.

4. A bush can be round or column shaped.

Cutting

1. Assume a secure position,

using two hands to hold the

trimmer and switch on.

2. Trim both sides of the

hedge, starting at the

bottom. This prevents

cuttings falling into the area

yet to be cut.

3. Pass the blade lightly

through the surface of the

hedge. Do not attempt to

cut too deep.

4. Trim the top of the hedge.

5. For older hedges that

require cutting back substantially, use pruning shears to

cut the thicker branches and then finish the job with the

hedge trimmer.

WARNING.

Do not let the blade come into contact with

fencing wire or any other object that could damage it.

HT18V

28/8/13 8:10:06 AM