Autonics ADIO-PN Instrukcja obsługi produktu - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Systemy wejścia/wyjścia Autonics ADIO-PN. Autonics ADIO-PN 10 stron. Remote i/o boxes (profinet)
Również dla Autonics ADIO-PN: Instrukcja obsługi produktu (10 strony)
Drukuj stronę
Port Connections
03. Connect with the atIOLink
Do not use the PDCT port and the Ethernet port at the same time.
04. Connect the power supply to ADIO
Be sure not to exceed 9 A of the maximum supplying current to the sensor (US).
01. Connect the M12 connector to the PDCT port. See the connections below.
Not Connected (N.C.)
1
Data -
1
2
2
3
Not Connected (N.C.)
5
4
Data +
4
3
5
02. Connect the connector to the network device.
• Network device: PC/laptop that atIOLink software is installed
03. Put the waterproof cover on the unused port.
01. Turn o昀昀 all power.
02. Connect the 7/8" connector to the power supply port. See the connections below.
4
5
5
4
3
3
2
1
1
2
PWR OUT
PWR IN
0 V
1, 2
0 V
Sensor and actuator supply
F.G.
Frame ground
3
+24 VDCᜡ
Sensor supply
4
+24 VDCᜡ
Actuator supply
5