Autopage RST-1100 Instrukcja obsługi - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zdalny rozrusznik Autopage RST-1100. Autopage RST-1100 20 stron. Remote engine starter with alarm system
Drukuj stronęIndoor Driving Paging
If the ignition switch is in the "off" position, press and hold the valet switch for 2
seconds to page the driver. One chirp sound shall be emitted from the vehicle and the
paging melody will sound from your Remote OLED transceiver. "DRIVER PAGING"
indication will flash on the OLED screen.
Q. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm with a unique feature which will turn on your vehicle dome light as following:
1. Upon disarming, the interior light will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn on the ignition switch or arm the alarm will turn off the dome light.
R. IGNITION CONTROL DOOR LOCK/UNLOCK.
If the vehicles door locks have been interfaced to the security system, the system will automatically lock the
vehicle's doors when the ignition is turned "ON" and /or unlock the vehicle's doors when the ignition is
turned "OFF".
S. TRUNK RELEASE (CHANNEL 3) OUTPUT.
Press and hold
button on the transmitter for three seconds to remotely control the
trunk release or other electric devices.
T. CHANNEL 4/5/6 TIMER CONTROL OUTPUT
Activate The Channel 4: Spin up the
press the transmitter
Activate The Channel 5: Spin up the
press the transmitter
Activate The Channel 6: Spin up the
press the transmitter
U. MULTI- VEHICLE SECURITY OPREATION:
Your remote transmitter can be utilized to control multi- vehicle security system, to program the remote
control transmitter to a second vehicle, follow the instructions for Transmitter programming. All
programming parameters will be the same except for the following:
For Regular Remote Control Transmitter:
1. Prior to pushing any button on the transmitter. Press the Select
II II II II
2. Once
button is pressed the LED on the transmitter will illuminate for 3.5 seconds to indicate the
second transmitter pin code is ON.
3. While the LED is illuminated, press any button on the remote control transmitter to control a second
vehicle security system.
For 2-way OLED Remote Control Transceiver:
A maximum of
four vehicle's
security
systems can be
controlled by
this transceiver.
RST1000 OP REV.A
switch to the page
and
buttons at the same time to active Channel 4 function.
switch to the page
and
buttons at the same time to active Channel 5 function.
switch to the page
and
buttons at the same time to active Channel 6 function.
TX1
and then press the "Channel 4" button or
3
and then press the "Channel 5" button or
3
and then press the "Channel 6" button or
3
II II II II
button first on the transmitter.
TX3
TX2
16
Jun/22/2009
TX4