Autopage RST-1100 Instrukcja obsługi - Strona 17
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zdalny rozrusznik Autopage RST-1100. Autopage RST-1100 20 stron. Remote engine starter with alarm system
Drukuj stronęSpin up the
switch
to the page 6
V. OUT OF RANGE
If this feature is
selected, the system will automatically check the range and update
the temperature every 33 minutes.
1. If the user is within the range, the
2. If the user is out of range, the remote will have five short "bi" sounds and the "Out
Of Range" icon will appear on the OLED screen.
Note: Programming "Out Of Range and Temperature Indication" will decrease the life
expectancy of the battery.
W. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state if the
power is lost and then reconnected.
A. TO REMOTE START THE VEHICLE:
1. Press the
button on the transmitter. Twice if safety start has been programmed.
2. The parking light will activate to indicate the remote start received the signal. (A
melody sound from your Remote OLED transceiver and "
OLED screen to confirm the remote start was activated.)
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after the parking lights will turn on again and your
climate controls will activate and adjust the vehicles interior temperature to your
Preset setting. (While the vehicle is running, the "Engine Running" icon and the
"minutes" digit on the OLED screen will flash. It will indicate a count down timer
based on the 5, 10, 20 or 30 minute run time set up by your installation center.)
5. The vehicle will run for a 5 to 30 minute cycle and automatically shut down. (When
the unit shuts off the count down timer will turn off and the transmitter will play a
melody.)
Note: The Remote Start Unit will not start the vehicle if any one of the following
conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF position. (If installed)
4. The gear selector is in any gear other then "PARK" or "NEUTRAL"
B. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START:
To operate the vehicle while engine running on the remote start.
1. Insert the ignition key and turn it to "ON" (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.
C. TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but
would like to leave the motor running and the climate control on.
1. Before turning off the engine, press the
programmed. The LED indicator will flash 3 times to confirm.
2.Turn the ignition key to OFF position. (The engine will stay running.)
3.The engine will run until the pre-programmed time elapsed or a shutdown input is received.
D. TURBO TIMER MODE:
RST1000 OP REV.A
The four transmitters will
be display on the OLED
screen, you can select
one of them through
your hand hold unit.
AND TEMPERATURE
icon will display on the OLED screen.
REMOTE START OPERATION:
(Factory defaults setting at active turbo timer mode.)
Press the button 3 and
the setting is done also
TX 3"
the "
will display
on the OLED screen
INDICATION:
" icon will flash on the
button on the transmitter. Twice if safety start has been
17
Jun/22/2009
Now you can press
button to remote control
TX 3 "
The "
vehicle's
security system.