Galeski CONTOUR CAT KS 80/3 Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sander Galeski CONTOUR CAT KS 80/3. Galeski CONTOUR CAT KS 80/3 13 stron. Wet edge polisher
Drukuj stronęGALESKI WERKZEUGE
milling cylinder GADIA CYLI G 100 (fine).
Attention! Safety goggles must be used dur-
ing the milling process!
2. Step: Grinding
Turn speed adjustment wheel to pos. C. Use
sufficient cooling water and grind thoroughly
while applying the grinding cylinders within
the range of R 200 to R 3000. The cylinders
R 200 and R 400 still take off a considerable
amount of material, therefore working time
with these should be limited.
Steady, even pressure of the tool to the ma-
terial will result in a steady oscillating motion
of the head. In order to achieve even wear of
the cylinder coating it is advisable to work
alternately with the upper and lower area of
the cylinder (especially when working on
slab thickness of 2-3 cm).
3. Step: Polishing
Use cylinder GADIA-CYLI Polisher. Turn
speed adjustment wheel to position B and
reduce water supply to a minimum.
To gain polishing results of highest quality
we recommend applying the polishing paste
GE 3 PAM after having finished work with
the machine.
4. Finishing the Work Session
Having finished the job, clean the felt coating
on the base plate of the edge polisher using
compressed air.
Renew the felt coating if it is excessively
dirty. By regulary doing so scratching prob-
lems will be avoided.
• After finishing work: it is important to
clean the machine and dry it by using
some compressed air.
10. CE-Declaration of Conformity
We declare under sole responsibility that this
product is in conformity with the following
standards or standardization documents:
EN 50144, EN 55014-1, EN 55014-2, EN
61000-3-2, EN 61000-3-3 according to the
provisions of the regulations 98/37/EC,
89/336/EEC.
In case of a modification of the electric pow-
er tool which we have not agreed to, the
above declaration becomes null and void
Operating Instructions CONTOUR CAT KS80/3 • ENGLISH
Frank Wegner
Product Development
– 9 –
and warranty expires.
11. Modifications
Text, pictures and data are correct at the
time of printing. In the interest of continuous
improvement of our products, technical spec-
ifications are subject to alteration without
prior notice.
12. Symbols
Do not dispose of electric tools
together with household waste!
In observance of European Di-
rective 2002/96/EC on waste
electrical and electronic equip-
ment and its implementation in
accordance with national law, electric tools that
have reached the end of their life must be col-
lected separately and returned to an environ-
mentally compatible recycling facility.
13. Technical Specifications
CONTOUR CAT KS 80/3
Voltage . . . . . . . . . . . . . 230 Volt / 115 Volt
Power Inp. . . . . . . . . . . .1500 W / 1300 W
Speed . . . . . . . . . . . . . . 2700 - 6500 r.p.m.
Weight . . . . . . . . . . . . . . . . . . . . . . . 6,5 kg
Working Spindle . . . . . . . . . . . . . . . . M 14
Height adjustment . . . . . . . . . . . . . 25 mm