Dynaudio Focus 20 XD Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Głośniki Dynaudio Focus 20 XD. Dynaudio Focus 20 XD 15 stron.
Również dla Dynaudio Focus 20 XD: Pierwsza konfiguracja (2 strony)
Drukuj stronę
Owner's Manual Focus XD
Selecting inputs on the
loudspeakers
►
Press the DIRECT button
on the
status LEDs will only be lit up when
remote control. The loudspeakers
the speaker is receiving commands
from the remote control. After a few
toggle between the analog and digital
input if the corresponding signal
seconds, the LEDs will turn off. Press
sources are connected.
the MOON button again to disengage
Night Mode.
Selecting the Hub or Connect inputs
Optionally, the loudspeakers can also be
Fixed Volume
►
operated with a Dynaudio Hub or Connect
Press and hold the MUTE button to
box. For details on operation via Hub or
set the volume to a fixed, high level.
Connect, please refer to the Connect
To disengage the Fixed Volume mode,
Owner's Manual.
simply change the volume level using
the Volume +/- buttons on the remote.
Selecting a Hub or Connect (HUB)
►
Press HUB A, B, or C on the remote
Disabling/Enabling Autosense
►
control. The chosen Hub or Connect is
In normal operation, the Focus XD will
selected as the signal source.
go to stand-by if it does not sense an
incoming signal. Hold the "Direct In"
Selecting an input on the Hub or
button on the remote for 5 seconds,
Connect (INPUT)
to disable or enable Autosense. The
►
Press INPUT 1, 2, 3, or 4 on the
status LED will blink once for enabling,
remote control. The selected signal
and twice for disabling Autosense.
source will be played back.
Note that when Autosense is off, the
speaker will remain On, until the user
Night Mode
actively sets the speaker in Stand-By
►
Briefly pressing the MOON button
using the Off button.
on the remote control will activate
Night Mode. When in Night Mode, the
20
Selecting inputs on the loudspeakers / Adjusting the volume
Adjusting the volume
Change the volume by pressing the
VOLUME button on the remote control.
►
Press
to turn the volume up.
►
Press
to turn the volume down.
Muting the loudspeakers
►
Briefly pressing the MUTE button on
the remote control will mute or unmute
the selected loudspeaker.
Note
If loudspeakers are operated in hub
mode in different zones, the volume
is controlled separately. For details
on operation via the Xeo hub,
please see the Xeo owner's manual.
dynaudio.com/focusxd
Display
The display on the top edge of the housing
indicates the operational state of the
loudspeakers and system using LEDs with
various colours and flash functions.
The display can be switched on or off with
the
button on the remote control.
LED DISPLAY MEANINGS
On-state
The bottom LED is illuminated in blue.
The bottom LED is flashing in blue.
The bottom LED is illuminated in violet.
Off-state
The bottom LED is illuminated dimly in red.
Display / Display meanings
The loudspeaker is switched on and an audio signal
connected to a Hub or Connect is played back.
The loudspeaker is switched on, but an audio signal
cannot be found on the selected input.
The loudspeaker is switched on and an audio signal
connected to a local input is played back.
The loudspeaker is in standby mode.
21