Dynaudio Audience SUB-30A Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Subwoofer Dynaudio Audience SUB-30A. Dynaudio Audience SUB-30A 19 stron.

frequency content from the main speakers. This is accomplished by changing the Output Filter

switch from <Flat> to <Lowcut 80 Hz>.

Multi-channel sound system

In multi-channel sound systems such as AC-3, AMPEG-2, and DTS, the dedicated subwoofer

(LFE; Low Frequency Effects) output from the surround decoder should be used (Fig. A).

If small loudspeakers are used throughout the surround setup, it is preferable to feed bass

signals from all five surround channels, and the subwoofer channel, to the subwoofer(s). If

multiple Dynaudio subwoofers are to be used, connect them with the Utility Link <Utility

In/Out>. Connect the Utility Link between two subwoofers as shown below. Example: two

subwoofers will act as one big subwoofer with a total of six inputs, three on each. It is very

important that all controls and switches are set in the same position on both subwoofers.

Use the three inputs <Left>, <Right>, and <Mono> on the first subwoofer for the respective

Left Front, Right Front, and Center channels. On the second subwoofer use the Left, Right, and

Mono input for the Left Rear, Right Rear, and Subwoofer channels (Fig. C).

(Fig. C)