Hikari H93S Instrukcja obsługi - Strona 18
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyna do szycia Hikari H93S. Hikari H93S 20 stron. Electrical control box
Drukuj stronę
E602
Hardware drivers fault
E603
Hardware drivers fault
E604
Motor signal error
E605
Motor signal error
E606
Hardware drivers fault
P.oFF
Power off Display
EvAL
Trial expired
L.bob
The bottom line tips
Remind of counting by
P.bob
piece
Feed motor STEP2 software
overcurrent
Feed motor STEP2 Current
detection circuit
Feed motor STEP2 The initial
mechanical angle
Feed motor STEP2 at the start,
Encoder or rotor stuck
Feed
motor
STEP2
Motor
winding circuit
Power off
Trial expired
The bottom line count value is
negative
The number of counting is 0
15
Current
detection
loop
system
properly;Whether the damage to the device driver
Current
detection
loop
system
properly;Whether the damage to the device driver.
Feed motor connector is a good contact
Feed motor connector is a good contact
Machinery is stuck
Current detection loop system is working properly;
Wether the damage to the device driver.
Wait for power supply to resume.
Contact the dealer processing
After replacing the bottom line, press P to cancel the
Alert Status
Press S key to enter the interface, and long press
"front seam" button for more than 2 seconds to
cancel the prompt state
is
working
is
working