AGS Merlin WTM Instrukcja instalacji i obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Przyrządy pomiarowe AGS Merlin WTM. AGS Merlin WTM 10 stron. Water temperature monitor
Drukuj stronęAGS WTM Installation, Operation & Maintenance
Operation
General
When power is supplied to the WTM controller, the LED on the logo will illuminate Red. To turn the WTM
controller off, disconnect electrical power supply.
When the temperature falls outside the maximum or minimum temperature setting, the water supply will be
turned off and an audible alarm will sound which can be turned off by pressing the MUTE button.
Press RESET to clear alarm condition and continue normal operation.
Display
The front display will show water supply status and current water temperature. To see MIN and MAX water
temperature settings press OK, programmed temperatures will be displayed for ~5 seconds.
Adjust Min and Max Allowable Water Temperature
Turn On the dipswitch [SET] located on the circuit board to program Min and Max water temperature.
Using Up and Down arrows located on the front fascia select required Min temperature.
Press OK and repeat for Max temperature. Turn Off the dipswitch [SET] to exit temperature programming
menu and save.
Rev 1 0223
7