AGS Merlin WTM Instructions d'installation et d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et d'utilisation pour {nom_de_la_catégorie} AGS Merlin WTM. AGS Merlin WTM 10 pages. Water temperature monitor

Imprimer la page

AGS WTM Installation, Operation & Maintenance

Operation

General

When power is supplied to the WTM controller, the LED on the logo will illuminate Red. To turn the WTM

controller off, disconnect electrical power supply.

When the temperature falls outside the maximum or minimum temperature setting, the water supply will be

turned off and an audible alarm will sound which can be turned off by pressing the MUTE button.

Press RESET to clear alarm condition and continue normal operation.

Display

The front display will show water supply status and current water temperature. To see MIN and MAX water

temperature settings press OK, programmed temperatures will be displayed for ~5 seconds.

Adjust Min and Max Allowable Water Temperature

Turn On the dipswitch [SET] located on the circuit board to program Min and Max water temperature.

Using Up and Down arrows located on the front fascia select required Min temperature.

Press OK and repeat for Max temperature. Turn Off the dipswitch [SET] to exit temperature programming

menu and save.

Rev 1 0223