Gama Garden GCS-2200E Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła łańcuchowa Gama Garden GCS-2200E. Gama Garden GCS-2200E 18 stron. Electric chain saw
Drukuj stronęclearance of at least 20 cm. If you now see
growing traces of oil, the chain lubrication system
is working correctly. If there are no traces of oil at
all, try cleaning the oil outlet (Fig 2, A), the upper
chain tensioning borehole and the oil duct, or
contact your Customer Service.
Check every 15 minutes the oil level during the
operation.
Chain lubricants
The service life of saw chains and guide bars
depends to a large extent on the quality of the
lubricant used. Old oil must not be used! Use only
environment-friendly chain lubricant. Store used
chain lubricant only in containers that comply with
the local regulations.
Guide bar
The guide bar is subjected to especially severe
wear and tear at the nose and the bottom. To
avoid one-sided wear and tear, turn the guide bar
over every time when you sharpen the chain.
Chain wheel
The chain wheel is subjected to especially high
wear and tear. If you notice deep wear marks on
the teeth, the chain wheel must be replaced. A
worn chain wheel curtails the service life of the
saw chain. Have the chain wheel replaced by a
specialist dealer or your Customer Service.
Chain guard
The chain guard must be clipped onto the chain
and sword as soon as the sawing work has been
completed and whenever the chainsaw has to be
transported.
Chain brake
(Fig 5)
In the event of kickback, the chain brake (Fig. 1,
5) will be actuated via the front finger guard. The
front finger guard is pushed forwards by the back
of the hand and this causes the chain brake to
stop the chain saw, or rather the motor, within
0.15 s.
Releasing the chain brake
To be able to use your chain saw again, you must
release the saw chain again. First switch off the
chainsaw. Then push the front finger guard back
into the vertical position. The chain brake is now
fully functional again.
Sharpening the saw chain
You can have your saw chain sharpened fast and
correctly by specialist dealers, from whom you
can also obtain chain sharpening equipment to
enable you to sharpen the chain yourself. Please
follow the corresponding operating instructions.
Take care of your tools. Keep your tools sharp
and clean to enable you to work well and safely.
Follow the maintenance regulations and the
instructions for changing tools.
Starting up
Always
wear safety
protective
gloves
clothes!
Use the saw only with approved extension cables
with the prescribed insulation and connections
designed
for
rubber-sheathed cables) which fit the chainsaw
plug.
To switch on:
hold the machine firmly with two hands and press
the Safety lock off button (Fig. 1, 12) while press
the On/Off switch (Fig. 1, 6).
If the chainsaw does not run, the chain brake
must be released at the front finger guard. Be
sure to read the sections "Chain brake" and
"Releasing the chain brake" on this point.
After switching on, the chainsaw will run
immediately at high speed.
To switch off:
Release the ON/OFF switch.
The release of ON/OFF switch results the stop of
the chainsaw within 1sec.
After working with the chainsaw, you should
always: Clean the saw chain and guide bar and
replace the chain guard.
11
11
goggles,
earmuffs,
and heavy-duty
outdoor
use
(approved
work