Gama Garden GCS-2200E Kullanım Kılavuzu - Sayfa 11

Testere Gama Garden GCS-2200E için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Gama Garden GCS-2200E 18 sayfaları. Electric chain saw

Sayfayı Yazdır

clearance of at least 20 cm. If you now see

growing traces of oil, the chain lubrication system

is working correctly. If there are no traces of oil at

all, try cleaning the oil outlet (Fig 2, A), the upper

chain tensioning borehole and the oil duct, or

contact your Customer Service.

Check every 15 minutes the oil level during the

operation.

Chain lubricants

The service life of saw chains and guide bars

depends to a large extent on the quality of the

lubricant used. Old oil must not be used! Use only

environment-friendly chain lubricant. Store used

chain lubricant only in containers that comply with

the local regulations.

Guide bar

The guide bar is subjected to especially severe

wear and tear at the nose and the bottom. To

avoid one-sided wear and tear, turn the guide bar

over every time when you sharpen the chain.

Chain wheel

The chain wheel is subjected to especially high

wear and tear. If you notice deep wear marks on

the teeth, the chain wheel must be replaced. A

worn chain wheel curtails the service life of the

saw chain. Have the chain wheel replaced by a

specialist dealer or your Customer Service.

Chain guard

The chain guard must be clipped onto the chain

and sword as soon as the sawing work has been

completed and whenever the chainsaw has to be

transported.

Chain brake

(Fig 5)

In the event of kickback, the chain brake (Fig. 1,

5) will be actuated via the front finger guard. The

front finger guard is pushed forwards by the back

of the hand and this causes the chain brake to

stop the chain saw, or rather the motor, within

0.15 s.

Releasing the chain brake

To be able to use your chain saw again, you must

release the saw chain again. First switch off the

chainsaw. Then push the front finger guard back

into the vertical position. The chain brake is now

fully functional again.

Sharpening the saw chain

You can have your saw chain sharpened fast and

correctly by specialist dealers, from whom you

can also obtain chain sharpening equipment to

enable you to sharpen the chain yourself. Please

follow the corresponding operating instructions.

Take care of your tools. Keep your tools sharp

and clean to enable you to work well and safely.

Follow the maintenance regulations and the

instructions for changing tools.

Starting up

Always

wear safety

protective

gloves

clothes!

Use the saw only with approved extension cables

with the prescribed insulation and connections

designed

for

rubber-sheathed cables) which fit the chainsaw

plug.

To switch on:

hold the machine firmly with two hands and press

the Safety lock off button (Fig. 1, 12) while press

the On/Off switch (Fig. 1, 6).

If the chainsaw does not run, the chain brake

must be released at the front finger guard. Be

sure to read the sections "Chain brake" and

"Releasing the chain brake" on this point.

After switching on, the chainsaw will run

immediately at high speed.

To switch off:

Release the ON/OFF switch.

The release of ON/OFF switch results the stop of

the chainsaw within 1sec.

After working with the chainsaw, you should

always: Clean the saw chain and guide bar and

replace the chain guard.

goggles,

earmuffs,

and heavy-duty

outdoor

use

(approved

work