DEAD FLY ZONE AMS-S1 Instrukcja montażu - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Odbiornik DEAD FLY ZONE AMS-S1. DEAD FLY ZONE AMS-S1 4 stron.

Assembly and Programming

1) Before attaching the mounting plate to the drum lid, run the float switch string through the

hole in lid. The string is already running through the mounting plate. If you're using your

own drum, you will have to drill a hole in your lid to accommodate the float switch string.

2) Place the Above-Drum Assembly on the drum lid so the pump intake fitting is directly

over the 3/4" threaded hole (Fig. 1). Align the 4 holes in the mounting plate with the 4

holes drilled in the lid. With the bolts, washers and nuts provided attach the mounting

plate to the lid and tighten. Once again, if you're using your own drum, you will have to

drill holes in your lid for the mounting plate. Use the mounting plate as a template and

use the provided hardware to attach the mounting plate to your lid.

3) Carefully turn over the lid and tie the float ball to the string and make sure that the

measurement from the lid to the end of the ball is approximately 25". You DO NOT want

the ball to hit the bottom of the drum when the lid is in place and the reservoir is empty.

Ideally, when the reservoir is empty, this float ball should hang about 6-8" from the

bottom of the drum. When the float ball is hanging straight down, it will pull the string

tight which will flip a switch in your pump, turning off the pump until the reservoir is

refilled. Running the pump and motor with an empty reservoir will burn out both units and

void your warranty.

4) Place the In-Drum Assembly tubing through the 3/4" threaded hole (Fig. 1), then thread

the pvc fitting into the hole (Fig. 1). Attach the supplied filter to the 3/8" tubing inside the

reservoir.