Deagostini Model Space HUMMER H1 Podręcznik - Strona 12
Przeglądaj online lub pobierz pdf Podręcznik dla Zabawka Deagostini Model Space HUMMER H1. Deagostini Model Space HUMMER H1 18 stron.
Drukuj stronęHUMMER H1: STEP BY STEP
1 1
Next, wrap the brake rod
(Stage 46) in a piece of
folded paper towel.
5 5
7 7
Your servo horn and brake rod assembly should look like this.
Hold the throttle linkage
rod (Stage 46) with
the needle-nose pliers,
covering it with a piece
of folded paper towel
or tissue for protection.
Screw the throttle ball end
(also Stage 46) onto the
threaded tip.
3 3
Carefully turn the servo
horn from right to left
until the tip of the rod
makes its way through to
the other side.
2 2
Turn the ball end until the remaining visible portion
of the threaded section measures 2mm.
Holding the brake rod
with the needle-nose
pliers, line up the tip of the
rod with the circled hole
on the servo horn. Make
sure you have the servo
horn the right way round,
with the recessed circle in
the central portion facing
upwards, as shown.
6 6
Insert a 2 × 8mm self-
tapping screw (Stage 46)
into the stepped/recessed
hole in the centre of the
linkage base (also Stage
46).
216
2mm
4 4
Push the front of the
servo horn down (upper
arrow) while lifting the
back up (lower arrow)
Keep going until the
portion of the rod that
appears vertical in the
photo is in the hole of
the servo horn.
8 8
™