Bristan Moloko Instrukcja montażu i lista zawartości - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja montażu i lista zawartości dla Produkt hydrauliczny Bristan Moloko. Bristan Moloko 12 stron. Thermostatic surface mounted bar shower valve with fast fit connections

Drukuj stronę

4.2 Installation

4.2.1 Fast Fit Fixing Kit (See Fig.1a)

4.2.1.1 Identify all components and check for completeness, particularly before

arranging fitting.

NOTE: - T

holes for the supply pipes check the centre dimension of the actual product to be used.

4.2.1.2 Inlet pipes need to terminate with at least 30mm of 15mm diameter pipe (not

supplied) protruding through the finished wall surface.

Important:- Water supplies to the mixer must be with the Hot on the left, & Cold on the

right when viewed from the front .

4.2.1.3 Place the wall plate (2) over the pipe and mark the hole centres, drill two holes

to suit the wall plugs (1) and insert the wall plugs into the freshly drilled holes in the

wall.

4.2.1.4 Place the wall plate (2) with onto the wall and tighten up the screws until

secure. Place the olive (3) onto the protruding 15mm pipe. The pipe needs to protrude

past the olive by 5mm maximum.

4.2.1.5 Screw the fixing bridge (4) onto the wall plate (2) using a 22mm a/f spanner,

holding the wall plate (2) with the flats provided with a 47mm spanner – DO NOT

tighten up the fixing bridge (4) against the fixings (1).

4.2.1.6 Screw shroud (5) onto fixing bridge (4).

For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk

Prior to drilling into walls, check there are no hidden electrical wires, cables or water

supply pipes with the aid of an electronic detector. If you use power tools do not forget:

•

Wear eye protection

•

Unplug equipment after use

fixing centres are a

NOMINAL DISTANCE

of 150mm, therefore before drilling