Bristan VAL2 BIB C 6 CD Instrukcje instalacji i podręcznik użytkownika
Przeglądaj online lub pobierz pdf Instrukcje instalacji i podręcznik użytkownika dla Produkt hydrauliczny Bristan VAL2 BIB C 6 CD. Bristan VAL2 BIB C 6 CD 2 stron.
Drukuj stronęSpecifications
Inlet Water Temperature
65°C
60°C
Maximum Static Pressure: 10.0 bar
60-65°C Recommended
Tools You'll Need
Flat Head
Crosshead
Adjustable
Screwdriver
Screwdriver
Spanner
Prior to Installation
All products manufactured and supplied by Bristan are safe provided
they are installed, used correctly and receive regular maintenance in
accordance with these instructions.
This product has been tested to the Water Regulations Advisory
Scheme (WRAS) and satisfies the requirements of the Water Supply
(Water Fittings) Regulations 1999 and current bylaws.
For full Installation Requirements & Notes (IRN) please visit
wras.co.uk/directory.
We recommend isolation valves to be fitted to the inlet water
supplies to ensure ease of future maintenance.
Before installing these taps the water supply must be
thoroughly flushed in order to remove any swarf, solder etc.
This product must not be modified in any way as this will
invalidate the guarantee.
If power tools are used do not forget to:
- Wear eye protection
- Unplug equipment after use
If in doubt, contact a registered plumber or your Local Water
Authority or the Secretary of the Institute of Plumbing, address
as follows:-
The Institute of Plumbing,
64 Station Lane,
Hornchurch,
Essex,
RM12 6NB, Tel: 01708 472791
Installation Instructions
& User Guide
Please leave these instructions
with the end user
Product Code: VAL2 BIB C 6 CD (D1)
Dynamic Water Pressure
Min: 0.2 bar
Max: 5.0 bar
3.0
3.0
2.0
2.0
1.0
4.0
1.0
4.0
0.2
5.0
0.2
5.0
Pressure
Pressure
BAR
BAR
Pipe Cutter
Drill
Pencil
Long-Nosed
Pliers
Pack Contents
x2
Spare Parts
To replace any spare parts
for your tap, why not
scan the QR Code or
visit www.bristan.com
and search for your product.
Installation
1
Create the rear
Inlet Connections
access point
in the back of
the wall cavity.
1/2" BSP
3
Safety
Goggles
Screw the shrouds on
to the tap bodies.
5
x2
Secure the taps by using washers and metal
backnuts behind the wall (not supplied).
2
Identify the required position of the taps and
prepare the water supply pipes.
Mark and drill holes. Finish the wall surface.
4
Feed the tap bodies
through the wall.
Connect the hot and cold water
6
supplies to the threaded tails.
We recommend using elbows
(not supplied).
Turn on water supply.