Gamma 5003 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyny naciągowe Gamma 5003. Gamma 5003 20 stron. 6 point mounting
Również dla Gamma 5003: Instrukcja obsługi (20 strony), Instrukcja obsługi (19 strony), Instrukcja obsługi (20 strony)
Drukuj stronę
ASSEMBLY INSTRUCTIONS
the knobs clockwise until they contact the inside of the racquet head at 6 and 12 o'clock.
MOUNTING THE FRAME
Height Adjustment
The turntable height can be adjusted to suit
the stringer. To adjust, loosen the two set
screws on the lower column support post
below the bellows assembly. Adjust the
amount of engagement between the upper
and lower column supports until the desired
height is attained. Make sure that the tension
track is still aligned with the long leg of the
base and tighten the two set screws to lock
the upper support column into place.
Mounting Stand Adjustment
Position the racquet frame over the
mounting stands and adjust the spacing
between the stands so the posts of the
frame support slides fit inside the head of
the racquet. By turning one of the knobs
located at either end of the turntable
counter clockwise the stands move closer
together. Turning clockwise will increase
the separation between the stands. With
the stands positioned so the posts of the
frame support slides are completely within
the head of the racquet frame, turn one of
Tightening the Frame Supports
Tighten the frame support slides by turning the
adjustment knob clockwise until snug against
the racquet frame and slight resistance is felt.
Caution: Overtightening the center supports
will stretch the head of the racquet and could
cause racquet damage.
8