Gamma 5003 Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Машины для изготовления струн Gamma 5003. Gamma 5003 20 страниц. 6 point mounting
Также для Gamma 5003: Руководство пользователя (20 страниц), Руководство пользователя (19 страниц), Руководство пользователя (20 страниц)

ASSEMBLY INSTRUCTIONS

the knobs clockwise until they contact the inside of the racquet head at 6 and 12 o'clock.

MOUNTING THE FRAME

Height Adjustment

The turntable height can be adjusted to suit

the stringer. To adjust, loosen the two set

screws on the lower column support post

below the bellows assembly. Adjust the

amount of engagement between the upper

and lower column supports until the desired

height is attained. Make sure that the tension

track is still aligned with the long leg of the

base and tighten the two set screws to lock

the upper support column into place.

Mounting Stand Adjustment

Position the racquet frame over the

mounting stands and adjust the spacing

between the stands so the posts of the

frame support slides fit inside the head of

the racquet. By turning one of the knobs

located at either end of the turntable

counter clockwise the stands move closer

together. Turning clockwise will increase

the separation between the stands. With

the stands positioned so the posts of the

frame support slides are completely within

the head of the racquet frame, turn one of

Tightening the Frame Supports

Tighten the frame support slides by turning the

adjustment knob clockwise until snug against

the racquet frame and slight resistance is felt.

Caution: Overtightening the center supports

will stretch the head of the racquet and could

cause racquet damage.