Centrometal CentroPelet ZR12 Instrukcje techniczne dotyczące instalacji, użytkowania i konserwacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcje techniczne dotyczące instalacji, użytkowania i konserwacji dla Kuchenka Centrometal CentroPelet ZR12. Centrometal CentroPelet ZR12 12 stron.
Drukuj stronęStandards and declarations of conformity
Legislation:
• Our company declares that the stove conforms
to the following standards for the European
Directive on CE marking.
• 89/336/EEC i 2004/108 EC (EMC directive)
and successive amendments.
• 2006/95/EEC (low voltage directive)
and successive amendments.
• 2006/42/EEC (machinery directive).
• 89/106/EEC (construction products).
•The installation of appliance has to be in
accordance with local and national laws and
with European standards.
• EN 60335-1 - EN 50165 - EN 50366 - EN
55014-1 - EN 61000-3-2 - EN 61000-3-3 - EN
14785.
Installation
Flue:
The flue must meet the following requirements:
• No other type of chimney, stove, boiler or hood
vent must be connected (fig.1).
• It must be placed at an adequate distance from
combustible or inflammable material by means
of an air cavity or appropriate
Figure 1. Method for installing the flue
3
NO
Responsibility:
The manufacturer does not accept any direct
or indirect, civil or criminal responsibility due to:
• Poor maintenance.
• Failure to observe the instructions contained in
the manuals.
• Use in non-conformity with the safety directives.
• Installation in non-conformity with the standards
in force in the country.
• Installation by unqualified or untrained personnel.
• Modifications and repairs not authorised by the
manufacturer.
• Use of non-original replacement parts.
• Exceptional events.
• Use of pellets not approved by the manufacturer.
• The internal section must be uniform, preferably
circular: the square or rectangular sections must
have rounded corners with a radius of no less
than 20 mm, a maximum relationship between
the sides of 1.5; the walls must be as smooth as
possible with no especially narrow sections,
irregular curves or discontinuities, with deviations
from the upper axes of not more than 45°.
YES