Jamar Radar Recorder Skrócona instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przyrządy pomiarowe Jamar Radar Recorder. Jamar Radar Recorder 4 stron.
Drukuj stronęStep 5 – Setting Up a Study: Programming the Radar Recorder
Now that we have the Radar Recorder installed, we're ready to program it to record data. Open the door of the Recorder
and connect the battery to the radar head to provide power. Once the recorder is powered on, connect your computer to it
using the cable that came with you equipment. Once connected, start the TRAXPro software.
Select 'Setup Radar
Recorder' from the
Tools & Preferences
section of the Quick
Start menu.
Step 6 – Checking Recorded Data in LiveView
Once the Recorder is
setup and recording, the
LiveView should be used
to check setup accuracy.
Click the Connect
Once connected,
button to have the
the main screen
TRAXPro software
shows the status.
Tap Settings to
connect to the Radar
Recorder.
setup distances.
As vehicles pass the
On the Main
detection zone...
Screen, tap
LiveView.
Set distances for
approach and recede
lanes, as well as
recorder head height.
Tap OK when done.
...the LiveView
screen should show
the speed and length
of the vehicle.
Message will show that setup
was successfully loaded. Click
OK to return to main screen.
Your study has begun and
you're now recording data.
Troubleshooting
If LiveView is not
showing vehicle data
as vehicles pass the
detection zone, check
that the Radar has been
aimed properly. The
crosshairs printed on
the face of the radar
head should be aimed
at a 45 degree angle to
the road.