Jamar Radar Recorder Skrócona instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przyrządy pomiarowe Jamar Radar Recorder. Jamar Radar Recorder 4 stron.

Step 7 – Securing the Radar Recorder and Monitoring Battery Life

Now that the Recorder has been installed, programmed and checked for accuracy, we're ready to leave it to do its job of

collecting data. Close the front door and latch it shut. Lock the unit into the mounting bracket, and lock the door latches,

using the locks provided. If you wish to add further security to the installation, the chain that was provided with the re-

corder can be wrapped around the pole through the bracket area, then locked in place.

Your Radar Recorder will record data for about seven days on one fully charged (6.4v or higher)

battery. If you will be collecting data for more than a few days at a time, we recommend that you pe-

riodically monitor the charge on the battery to be sure that you get good data throughout the duration

of your study. To do this, open the Recorder, connect the computer and connect to the Radar Record-

er. The main battery voltage is displayed in the Radar Recorder Setup screen, as shown here.

Replace and recharge your battery once the voltage falls between

Step 8 –Downloading Data from the Radar Recorder to the Computer

Note: The Radar Recorder can either be downloaded in the field to a laptop, or brought back into the office to download to a desktop.

Connect the Interface

cable from the

computer to the Radar

Recorder and start the

TRAXPro software.

Select 'Download

Traffic Recorder' from

the Download section

of the Quick Start

menu.

Once the file is saved, it

will appear in TRAXPro.

You can then process the

file and produce reports.

5.8 - 5.7

volts.

Click on Download

Radar Recorder... ... then click on

Begin Download.

Data will begin

to transfer to the

computer from the

Radar Recorder.

Once the download

is complete, you'll

be asked to save the

file. Select a folder,

give the file a name

and click Save.