Century Helicopter Products CN1074 Podręcznik - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik dla Zabawka Century Helicopter Products CN1074. Century Helicopter Products CN1074 15 stron.

Drukuj stronę

Century Helicopter Products CN1074 Podręcznik

STEP 12 Landing Gear

Insert all the M3x4 Set Screws into the landing gear components. Slide two landing gear mounts onto the straight

struts and align to the hole spacing on the lower side frames, notice that the rear mount face backwards and the

front mounts are forward. Once centered, verify both are level and secured by tightening the M3x4 Set

Screw on each mount. Slide the plastic vertical struts onto the ends of the straight struts, notice that the

vertical struts should slant forward and insert the aluminum skids from the front to the rear, positioning

the wheel mount inbetween. Position the end of the aluminum skid 15mm past the end of the rear strut

and tighten the M3x4mm Set Screws at the bottom. Before tightening any other set screws, measure the

distance between the aluminum skids at the back and front, slide the vertical struts to match the distances.

Lay the mechanics onto the landing gear mounts and position the front strut assembly to align the holes.

Finally, tighten all the remaining M3x4 Set Screws to lock the landing gear in place. Bond the skid caps in

place with CA or epoxy. Attach the wheels with two M3x15 Socket Cap Screws.

Aluminum

Skids x 2

[CN1074-19]

STEP 13 Truss & Rudder Mounts

Insert two M3x40 Socket Cap Screws through

one tail truss mount, through the main mechanics

and slide the rudder servo mount and the second

tail truss mount from the other side. Secure with

two M3 Locknuts.

Tail Truss

Assembly

[CN1074-10]

Vertical

Struts x 4

Landing Struts

[CN1074-20]

M3x4 Set

Screws x 14

Aluminum

Skids x 2

M3x12 Self

Tapping

Screws x 4

Landing Gear

Mounts x 4

Tail Truss

Mount x 2

[CN1074-11]

Rudder Servo

Mount

[HW3116]

STEP 14 Mounting Tail Truss & Mechanics

Gently flex the upper tail truss fittings to overlap the tail

truss mounts and secure using two M3x10 Socket Cap

Screws using threadlock. Insert two M3x15 Self Tapping

Screws through the lower tail truss legs (may require

slight bending to align the holes as a result of manufac-

ture, cracking of the powder coat surface may occur

however it is purely cosmetic and can be repainted), the

lower side frames and into the landing gear mounts.

Insert two M3x12 Self Tapping Screws through the front

landing gear holes into the landing gear mounts.

Bell47G II Detail Manual

Straight

Struts x 2

Landing

Gear Set

[CN1074-21]