Britax R032S Series Podręcznik - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik dla Meble dla niemowląt i małych dzieci Britax R032S Series. Britax R032S Series 6 stron. Portable cot

Drukuj stronę

BEFORE ASSEMBLING THIS COT READ AND UNDERSTAND THE INSTRUCTIONS.

INCORRECT ASSEMBLY MAY MAKE THE COT UNSAFE. KEEP THESE INSTRUCTIONS IN A

SAFE PLACE FOR FUTURE REFERENCE.

WARNINGS

Never leave your child unattended.

Do not use your cot if any part is broken, torn or missing.

Do not use or leave the cot near open ﬁres, naked ﬂames, electric bar ﬁres, gas ﬁres,

stoves, heaters or barbecues.

Do not place the cot where your child could reach medication, money, string, elastic,

small toys or other small objects.

Do not place the cot near trailing cords, leads or ﬂexes such as cords or electrical

leads, etc.

Do not use additional mattress or padding.

Do not place toys or other objects in the cot which could provide a step or foothold to help

the child climb out.

Cots with padded rails should not be used if the covered fabric is torn or bitten through.

Do not use parts or accessories except those tested and approved by Steelcraft.

Always check that the folding parts are fully locked before using the cot.

Do not place more than one child in the cot at the same time.

Do not use this cot with a child who can climb out, weighs more than 15kg, or is taller than

90cms.

When using a ﬁtted sheet it must ﬁt the mattress tightly.

Check that the assembly of the cot is correct and safe.

The thickness of the mattress has been speciﬁed to ensure that the distance from the top

of the mattress to the top of the lowest side or end will always be at least 500mm. This will

reduce the risk of children falling out of the cot.

Always check parts regularly for tightness of screws, nuts and other fasteners - tighten

if required.

Use only the mattress supplied with the cot.

Do not use an additional mattress, padding, toys or other objects in the cot which would

help your child fall out.

Using the wrong size mattress may create hazardous gaps that could result in suffocation

or could reduce the side height of the cot, which may result in your child falling out

of the cot.

THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE.

www.britax.com.au

CARE AND MAINTENANCE

To prolong the life of your nursery product keep it clean and do not leave it in the direct

sunlight for extended periods of time.

Removable fabric covers and trims may be cleaned using warm water with a household

soap or a mild detergent. Allow it to dry fully, preferably away from the direct sunlight.

DO NOT DRY CLEAN, OR USE BLEACH.

Do not machine wash, tumble or spin dry, unless the care labelling on the product permits

these methods.

Non removable fabric covers and trims may be cleaned using a damp sponge with soap

or mild detergent. Allow it to dry completely before folding or storing it away.

In some climates the covers and trims may be affected by mould and mildew. To help

prevent this occurring, do not fold or store the product if it is damp or wet. Always store

the product in a well ventilated area.

To maintain the safety of your nursery product, seek prompt repairs for bent, torn, worn

or broken parts. Use only those parts and accessories tested and approved

by Steelcraft.

WARNING: IF THE SIDES DO NOT LATCH FIRMLY OR THERE ARE HOLES IN THE

MESH SIDES, DISCONTINUE USE IMMEDIATELY AND SEEK REPAIR.

TESTED AND APPROVED ACCESSORIES

Mattress by Steelcraft

- series R032S

Bassinet by Steelcraft

- series R032S

Change Table by Steelcraft

- series R032S