IKEA NUTID HGA4K Podręcznik - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik dla Hob IKEA NUTID HGA4K. IKEA NUTID HGA4K 20 stron.
Również dla IKEA NUTID HGA4K: Podręcznik (15 strony)
Drukuj stronę
ENGLISH
- The connection of the hob to the gas
pipe network or gas cylinder must be
made by means of a rigid copper or
steel pipe with fittings complying with
local regulations, or by means of a
continuous-surface stainless steel hose
complying with local regulations. The
maximum length of the hose is 2 linear
metres.
A
C
- Connect elbow (A)* or (B)* supplied with
to the hob inlet main pipe and interpose
the washer (C) supplied, in compliance
with EN 549.
- Use elbow (A) for France and elbow (B)
- IMPORTANT: if a stainless steel hose
- After connection to the gas supply, check
Electrical connection
- This operation must be performed by a
- The electrical connections must comply
- The earthing of this appliance is
- Do not use an extension cord.
B
- IMPORTANT: the data relevant to the
Assembly
C
After having cleaned the perimeter surface,
apply the supplied gasket to the hob.
Position the hob in the worktop opening
made respecting the dimensions indicated
in the Instruction.
NOTE: the power supply cable must be long
enough to permit its upward extraction.
To secure the hob, use the brackets provided
with it. Fit the brackets into the relevant
bores shown by the arrow and fasten them
by means of their screws in accordance with
the thickness of the worktop.
for all other destinations.
is used, it must be installed so as not to
touch any mobile part of the furniture.
It must pass through an area where
there are no obstructions and where it is
possible to inspect it on all its length.
for leaks with soapy water. Light up the
burners and turn the knobs from max
position to minimum position
check flame stability
WARNING
qualified technician.
with local regulations.
compulsory by law.
voltage and power absorption are
indicated on the rating plate.
1 1
to
L
Earth
(yellow/green)
N