IKEA IUD9500WX4 Instrukcja instalacji - Strona 20

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Zmywarka IKEA IUD9500WX4. IKEA IUD9500WX4 48 stron. Undercounter dishwasher
Również dla IKEA IUD9500WX4: Instrukcje użytkownika (25 strony)

Drukuj stronę

.....................................

.;,upp }÷

Be sure rubber washer is properly seated in fitting. Slide the

3/4"fitting up to the valve and hand tighten to avoid cross-

threading. Hand tighten until the coupling is tight.

Using pliers, check the tightness of the coupling. An additional

1/4to 1/2turn may be required to seal the rubber gasket.

NOTE: Do not overtighten. Damage to the coupling can result.

Place paper towel under 90 ° elbow fitting. Turn on water supply

and check for leaks. If leak occurs, repeat previous step.

If needed, see website for animated representation

of this step.

Visit www.ikea.com/watersupply

under FAQ tab.

NOTE: Do not use Teflon ®ttape with compression

fittings.

t®TEFLON

is a registered

trademark of E.I. Du Pont De Nemours and Company.

NOTES:

•

To help minimize vibration, route drain hose to avoid contact

with motor, door springs, water line, cabinet, flooring or the

edge of the hole when it passes through the cabinet.

•

Do not remove drain loop from side of dishwasher.

Green clam

Black drain hose

Drain hose

connect(

Place towel under drain hose to catch any water in drain hose.

Place the small green drain hose clamp onto the small end of the

drain hose. Push the new drain hose into the black drain hose

connector up to the drain hose stop.

Using pliers, squeeze open the small green drain hose clamp and

slide onto connector between stops.