Makita 3612 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 3612. Makita 3612 20 stron. Guide rail adaptor
Również dla Makita 3612: Podział części (3 strony), Instrukcja obsługi (16 strony)

Drukuj stronę

1. Stopper pole

2. Hex bolt

3. Hex nut

4. Stopper block

1. Switch lever

1. Lock-off button

2. Switch trigger

1. Speed adjusting dial

Stopper block

003657

The stopper block has three adjusting hex bolts which raise or lower 0.8 mm

per turn. You can easily obtain three different depths of cut using these adjust-

ing hex bolts without readjusting the stopper pole.

Adjust the lowest hex bolt to obtain the deepest depth of cut, following the

method of "Adjusting depth of cut". Adjust the two remaining hex bolts to

obtain shallower depths of cut. The differences in height of these hex bolts are

equal to the differences in depths of cut.

To adjust the hex bolts, first loosen the hex nuts on the hex bolts with the

wrench and then turn the hex bolts. After obtaining the desired position,

tighten the hex nuts while holding the hex bolts in that desired position. The

stopper block is also convenient for making three passes with progressively

deeper bit settings when cutting deep grooves.

Switch action

For tool without lock-off button

003660

CAUTION:

•

Before plugging in the tool, always check to see that the tool is switched

off.

•

Make sure that the shaft lock is released before the switch is turned on.

•

Hold the tool firmly when turning off the tool, to overcome the reaction.

To start the tool, move the switch lever to the I (ON) position. To stop the tool,

move the switch lever to the O (OFF) position.

For tool with lock-off button

005066

CAUTION:

•

Before plugging in the tool, always check to see that the switch trigger

actuates properly and returns to the "OFF" position when released.

•

Make sure that the shaft lock is released before the switch is turned on.

To prevent the switch trigger from being accidentally pulled, a lock-off button is

provided

To start the tool, push in the lock-off button and pull the switch trigger. Release

the switch trigger to stop.

Speed adjusting dial

For model 3612C only

003802

The tool speed can be changed by turning the speed adjusting dial to a given

number setting from 1 to 5.

Higher speed is obtained when the dial is turned in the direction of number 5.

And lower speed is obtained when it is turned in the direction of number 1.

This allows the ideal speed to be selected for optimum material processing,

i.e. the speed can be correctly adjusted to suit the material and bit diameter.

Refer to the table for the relationship between the number settings on the dial

and the approximate tool speed.