CORNING SRP-004-067 Instrukcja serwisowa - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Kable i złącza CORNING SRP-004-067. CORNING SRP-004-067 4 stron. Access tool for sst-drop cables

Drukuj stronę

Step 3:

Open the tool and insert the cable so

that the tape wrap applied in Step 1 is

just behind the blades. Close the tool

(Figure 3).

Step 4:

Firmly hold the cable with one hand and

use your other hand to pull the tool along

the cable until the tool is clear of the end

of the cable (Figure 4).

Step 5:

Use scissors to remove the split sections

of the cable jacket and to cut the

strength members as flush as possible to

the cable jacket (Figure 5). Use care to

avoid damaging the buffer tube. Access

the fibers as described in SRP-004-067.

Mid-span Access

Step 1:

Measure and mark the strip length

required for your application, marking

the length with wraps of electrical tape. If your cable has a toning wire, apply the tape

wraps only on the optical cable - do not cover the toning wire.

Step 2:

If applicable, separate (but leave intact the toning wire from the cable as described in

SRP-004-067. Remove any web remnants on the optical cable jacket as described in that

procedure.

STANDARD RECOMMENDED PROCEDURE 005-066 | ISSUE 4 | JULY 2010 | PAGE 2 OF 4

Front edge of

tape wrap

KPA-2457

Figure 3 — Tool placement

KPA-2459

Figure 5 — Strength member removal

Note blade locations

KPA-2458

Figure 4 — Tool use