CORNING SRP-004-067 Instrukcja serwisowa - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Kable i złącza CORNING SRP-004-067. CORNING SRP-004-067 4 stron. Access tool for sst-drop cables

Drukuj stronę

Step 3:

Separate the tool halves by fulling opening the tool - its marking arrows must be aligned -

and then press the tool halves away from each other (Figure 6).

Step 4:

Position tool over cable:

a) Align the tool half arrows and reas-

semble the tool over the cable mid-

span access area (Figure 7, top).

b) Position the tool so that its blades are

just inside one of the tape wraps

applied in Step 1 (Figure 7, middle).

c) Close the tool (Figure 7, bottom).

Step 5:

Firmly hold the cable with one hand

and use your other hand to pull the

tool along the cable until the tool's

blades are just inside of the other

tape wrap (Figure 8).

Step 6:

Open the tool and repeat Step 3 to

remove the tool from the cable.

STANDARD RECOMMENDED PROCEDURE 005-066 | ISSUE 4 | JULY 2010 | PAGE 3 OF 4

KPA-2460

Figure 6 — Tool half separation

Note blade

locations

Front edge of

tape wrap

Figure 7 — Mid-span tool placement

Figure 8 — Midspan tool use

KPA-2461

KPA-2462