Makita 6805BV Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 6805BV. Makita 6805BV 8 stron. Variable speed/reversing
Również dla Makita 6805BV: Instrukcja obsługi (12 strony)
Drukuj stronę
1. Reversing switch lever
2
1
3
1. Locator
2. Adjusting ring
3. Pointer
ASSEMBLY
1
1. Front cap
6
NOTE:
•
Even with the switch on and motor running, the bit will not rotate until you
fit the point of the bit in the screw head and apply forward pressure to
engage the clutch.
Reversing switch action
004159
CAUTION:
•
Always check the direction of rotation before operation.
•
Use the reversing switch only after the tool comes to a complete stop.
Changing the direction of rotation before the tool stops may damage the
tool.
1
This tool has a reversing switch to change the direction of rotation. Move the
reversing switch lever to the
tion for counterclockwise rotation.
Adjusting the fastening torque
004163
When you wish to drive machine screws, wood screws, hex bolts, etc. with the
predetermined torque, adjust the fastening torque as follows.
The fastening torque may be adjusted by turning the adjusting ring. Before
turning the adjusting ring, turn the locator in the direction of the arrow as far as
it will go without forcing. The torque is increased by turning the adjusting ring
in the direction of the arrow and decreased by turning it in the opposite direc-
tion. Align the number 1 on the adjusting ring with the pointer on the gear
housing. Drive a trial screw into your material or a piece of duplicate material.
If the fastening torque is not suitable for the screw, continue adjusting until the
proper torque is obtained.
CAUTION:
•
The adjusting ring should be turned only within the numbered range. It
should not be forced beyond this range.
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing the bit
004166
To remove the bit, first pull the front cap off and then pull the bit out firmly.
To install the bit, insert it into the tool as far as it will go and then replace the
front cap.
position for clockwise rotation or the
posi-