Makita 6904V Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 6904V. Makita 6904V 8 stron. Impact driver

Drukuj stronę
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
Reversing switch action
002322
This tool has a reversing switch to change the rotational
direction. Press the upper side (FWD side) for clockwise
(forward) rotation or the lower side (REV side) for
counterclockwise (reverse) rotation.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.

Speed change

002329
To change the speed, first switch off the tool and then
slide the speed change lever fully to the "H" side (lower
side) for high speed or to the "L" side (upper side) for low
speed. Before starting operation, ensure that the speed
change lever is slid fully to the desired side. Select the
speed optimum for your job.
CAUTION:
Do not use the speed change lever while the tool is
•
running. The tool may be damaged.
1. Reversing
switch
1
1. Speed change
lever
1
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing driver bit or socket bit
004521
Use only bits that has inserting portion shown in the
figure.
Do not use any other driver bit or socket bit.
For tool with shallow bit hole
Use only these type of bit. Follow the
A=12mm
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
A=17mm
To install these types of bits, follow
the procedure (1).
B=14mm
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
011405
1.
To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far as
it will go. Then release the sleeve to secure the bit.
1
011406
2.
To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
5
1. Bit
2. Sleeve
2