Makita 6904V Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 6904V. Makita 6904V 8 stron. Impact driver

Drukuj stronę
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
2
3
1
011407
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the sleeve,
•
the sleeve will not return to its original position and
3.7 mm x 50 mm
3.8 mm x 60 mm
4.5 mm x 90 mm
4.5 mm x 120 mm
6.0 mm x 150 mm
5.5 mm x 180 mm
011481
NOTE:
Use the proper bit for the head of the screw/bolt
•
that you wish to use.
Hold the tool pointed straight at the screw or the
•
screw and/or bit may be damaged.
When driving wood screws, predrill pilot holes to
•
make driving easier and to prevent splitting of the
workpiece. The pilot holes should be slightly
smaller than the wood screws in diameter.
1. Bit
2. Bit-piece
3. Sleeve
0
the bit will not be secured. In this case, try
re-inserting the bit according to the instructions
above.
When it is difficult to insert the bit, pull the sleeve
•
and insert it into the sleeve as for as it will go.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.

OPERATION

Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw. Start the tool
slowly and then increase the speed gradually. Release
the switch trigger just as the screw bottoms out.
Please the trigger just as the screw bottoms out. The
relation between screw size and fastening time is shown
the graph below.
Material to be fastened : Lauan
5
Fastening time
The size of wood screw which can be fastened with
•
this tool may differ depending upon the type of
material to be fastened. Always perform a test
operation to determine the size of wood screw.
When fastening bolts or nuts, always perform a test
•
operation to verify the adequate fastening time for
your bolt or nut. Excessive fastening torque may
damage the bolt/nut or socket bit.
6
: At high speed
: At low speed
10
Seconds