Makita BJV180 Informacje techniczne - Strona 10
Przeglądaj online lub pobierz pdf Informacje techniczne dla Elektronarzędzie Makita BJV180. Makita BJV180 13 stron. Cordless jig saw
Również dla Makita BJV180: Podział części (3 strony), Arkusz specyfikacji (2 strony), Instrukcja obsługi (13 strony), Instrukcja obsługi (13 strony), Instrukcja obsługi (13 strony), Instrukcja obsługi (18 strony)
Drukuj stronę
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Armature
DISASSEMBLING
1) Remove Handles (R) and (L) and Gear housing cover section. (Figs. 6, 7 in page 4)
2) Remove Retaining ring S-8 from the shaft portion of Gear housing complete.
By tapping the end surface of Gear housing complete with plastic hammer, remove the assembly of reciprocating
mechanism (including Crank complete, Balance plate, Gear complete) from Gear housing complete. (Fig. 33)
3) Remove Gear housing complete from Motor section by unscrewing four 4x30 Tapping screws. (Fig. 34)
4) Remove Brush holder caps and Carbon brushes from Motor housing.
5) By unscrewing four 4x18 Tapping screws, Motor section can be disassembled as illustrated in Fig. 35.
Fig. 33
Retaining ring S-8
Crank complete
Balance plate
Gear complete
assembly of
reciprocating mechanism
Fig. 35
Motor housing (R)
Motor housing (L)
ASSEMBLING
Do the reverse of the disassembling steps.
Important:
Yoke unit is not reversible when assembled to Armature. Be sure to assemble so that the red mark of Yoke
unit is positioned on the drive-end side of Armature as illustrated to left in
Note 1: Because Armature is pulled strongly towards Yoke unit by the magnet force of Yoke unit;
1) Be sure to hold the gear portion of Armature as illustrated to left in
as illustrated to right or your fingers will be pinched between Yoke unit and the fan of Armature.
2) Be careful not to damage the copper wire of Armature.
Fig. 36
[Correct]
Red marking
Gear housing
complete
Tapping screw 4x18 (4 pcs)
[Wrong]
Red marking
Fig. 34
Tapping screw 4x30 (4 pcs)
Armature
Yoke unit
Endbell complete
Fig. 36.
Fig. 37. Do not hold the Armature core
Fig. 37
[Correct]
P 10/13
Armature remains in
Motor section in this step.
Motor section
[Wrong]
Your fingers can be pinched
and injured.