KitchenAid 30" Freestanding Range Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Piekarnik KitchenAid 30" Freestanding Range. KitchenAid 30" Freestanding Range 13 stron. (61cm), (68.6cm), and (76.2cm) indoor/outdoor electric warming drawer
Również dla KitchenAid 30" Freestanding Range: Instrukcja instalacji (8 strony), Instrukcje instalacji (5 strony), Instrukcje instalacji (5 strony), Instrukcja instalacji (16 strony)

Drukuj stronę

Check operation of oven broil

burner

29.

Close the oven door. Press the

"BROIL " pad. "500˚F" will appear in the

temperature display. Press the "START"

pad. The oven broil burner should light in

50 to 60 seconds. This delay is normal.

The oven safety valve requires a certain

time before it will open and allow gas to

flow. The first time broil burner is lighted,

it may take longer to light because of air

in gas line. The first few times burner is

used sparks may appear. This is normal.

NOTE: Oven door must be shut for broil

burner to operate.

30.

Look through oven window to

check broil burner for proper flame. The

flame should have a uniform, light blue

appearance around the burner surface.

No yellow tips, blowing or lifting of the

flame should occur.

NOTE: The first few times the broil

burner is used, yellow sparks may

appear in the flame. This is normal and

will stop after burner has been used a

few times.

If range does not

operate:

Check that the circuit breaker is not

tripped or the house fuse blown.

Check that the power supply cord is

plugged into the outlet.

Check that gas line is turned on.

See Use and Care Guide for

troubleshooting list.

31.

Press the "CANCEL/OFF" pad. If

the broil burner flame needs adjustment,

contact your KitchenAid dealer or

authorized service company for

assistance.

32.

Insert storage drawer into slide

rails on sides of drawer opening. Lift

front of drawer slightly and push firmly

to close drawer.

L.P . gas conversion

No attempt shall be made to convert the

range from the gas specified on the

model/serial rating plate for use with a

different gas without consulting the

servicing gas supplier. An L.P . Gas

Conversion Kit is included in your

literature package.

Moving the range

WARNING

Tip Over Hazard

A child or adult can tip the range and

be killed.

Connect anti-tip bracket to rear

range foot.

Reconnect the anti-tip bracket, if the

range is moved.

Failure to follow these instructions can

result in death or serious burns to

children and adults.

When moving range, slide range onto

cardboard or hardboard to prevent

damaging the floor covering.

If removing the range is necessary for

cleaning or maintenance:

1. Remove the storage drawer.

2. Shut off gas supply to the range.

You have just finished installing

your new range. To get the

most efficient use from your

range, read your Use & Care

Guide. Keep Installation

Instructions and Guide close to

range for easy reference. The

instructions will make installing

the range in another home as

easy as the first installation.

3. Disconnect gas.

4. Unplug range or disconnect power.

5. Slide range forward to complete

cleaning or maintenance.

6. Make sure the anti-tip bracket is

installed:

• Look for the anti-tip bracket securely

attached to floor.

• Slide range back so rear range foot

is under anti-tip bracket.

range foot

Check that range is level.

8. Reconnect gas line to range and

check for leaks.

9. Plug in range or reconnect power.

10. Reinstall storage drawer.

anti-tip

bracket