Gardena HighCut 48-Li 8882 Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Trymer Gardena HighCut 48-Li 8882. Gardena HighCut 48-Li 8882 15 stron.
Drukuj stronę
G
F
8. Troubleshooting
G
F
Fault
Hedge trimmer does not start
Hedge Trimmer does not
start / starts only briefly
Hedge is not cleanly cut
Charging indicator lamp does
not light up
Charging indicator lamp
flashes for more than
1 hour
The battery can no longer
be charged
Telescopic tube slips despite
clamped clamping lever / s
20
ATTENTION ! Damage to the hedge trimmer !
V Never clean the hedge trimmer under running
A
water or with a water jet (in particular a high
pressure water jet).
1. Clean the hedge trimmer with a damp cloth.
2. Lubricate the trimmer blade
GARDENA spray-oil Art. 2366). Avoid contact of the oil with
the plastic parts and wear gloves.
DANGER ! Risk of physical injury !
Cutting injuries can be caused if the hedge trimmer
A
does switch on unintentionally.
V Remove the battery before troubleshooting
(see 4. Initial Operation) and slide the protective
F
cover
Possible cause
Battery is flat.
Battery not pushed onto
the handle properly.
When rotating the cutting unit, it
was not engaged at 0° or 90°.
When tilting the swivel head, it
was not engaged between 75°
and -45°.
Hedge Trimmer overheats.
Blade blunt or damaged.
Battery not plugged in
properly.
A fault has occurred.
Battery is defective.
Only the original GARDENA Replacement Battery 18 V
(Art. 8835 / 8839) may be used. This can be obtained from
your GARDENA dealer or directly from GARDENA Service.
Nut / s loose on clamping lever / s. v Tighten nut / s on clamping
G
with a low viscosity oil (e.g.
over the cutter blade
Remedy
v Charge battery (see
4. Initial Operation).
v Push battery onto the handle
and make sure that the
locking buttons snaps in
correctly.
v When rotating the cutting
unit, engage it at 0° or 90°.
v When tilting the swivel head,
engage it between 75° and
-45°.
v Let Hedge Trimmer cool for
30 seconds.
v Have blade replaced by
GARDENA-Service.
v Plug in battery charger and
charging cable properly.
v Unplug and reinsert
charging cable. The fault
will be reset.
v Replace the battery
(Art. 8835 / 8839).
lever / s using a 10 mm
spanner.
G
.