Gardena 4000/5 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt do trawników i ogrodów Gardena 4000/5. Gardena 4000/5 17 stron. Garden pump
Również dla Gardena 4000/5: Instrukcja obsługi (10 strony), Instrukcja obsługi (17 strony), Instrukcja obsługi (12 strony), Instrukcja obsługi (14 strony), Instrukcja obsługi (11 strony), Instrukcja obsługi (10 strony), Instrukcja obsługi (18 strony), Instrukcja obsługi (10 strony), Instrukcja obsługi (19 strony), Instrukcja obsługi (13 strony)

Note

v Protect the pump from rain. Don't use the

pump in wet or moist area.

In order to avoid dry-running of the pump, take

care that the end of the suction hose is always

submerged into the liquid.

v Before each operation, fill the pump to over-

flowing with approx. 2 to 3 l of the liquid to be

pumped!

3. Initial Operation

Setting up your Garden Pump:

Connecting hose to

suction side:

Sand and other abrasive substances in the liquid

cause in-creased wear and reduce the pump's

output.

Pumping dirty water, e.g. stones, pine needles

etc., can cause damage to the pump.

v Do not pump dirty water.

The minimum flow rate is: 4000/5: 90 l/h

(= 1.5 l/min); 5000/5: 200 l/h (= 3.3 l/min).

Watering accessories with lower rate must not

be operated.

The site must be firm and solid in order to ensure safe and sturdy

operating conditions for the pump.

v Position the pump at a safe distance (min. 2 m) from the liquid

to be pumped.

The pump must be installed in a location with low air humidity

and sufficient ventilation in the area of the ventilation slots.

It must be at a distance of at least 5 cm from the walls.

No dirtcontamination (e.g. sand or earth) may be sucked in

through theventilation slots.

Don't use any hose connection system fittings on the

suction side! A vacuum-resistant suction hose must be used,

e. g. GARDENA Suction Unit, art. no. 1411.

In order to reduce the suction time, it is advisable to use a suction

hose with backflow preventer avoiding automatic draining of the

suction hose when the pump is stopped.

1. Screw a vacuum-resistant suction hose

connector on the suction side of the pump

2. For suction heights exceeding 4 m also secure the suction

hose

(e.g. by fastening it to a wooden post).

This relieves the pump of the weight of the suction hose.

airtight onto the