Makita 6013B Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wiertarka Makita 6013B. Makita 6013B 6 stron. 13 mm (1/2")
Również dla Makita 6013B: Instrukcja obsługi (8 strony), Instrukcja obsługi (8 strony), Instrukcja obsługi (20 strony)

Drukuj stronę

Model 6013BR (Fig. 5)

The switch is reversible, providing either clockwise or

counterclockwise rotation. To start the machine, sim-

ply pull the lower part of the switch for clockwise, the

upper part for counterclockwise. Release the switch

to stop.

Drilling operation

• Drilling in wood

When drilling in wood, best results are obtained with

wood drills equipped with a guide screw. The guide

screw makes drilling easier by pulling the bit into the

workpiece.

• Drilling in metal

To prevent the bit from slipping when starting a hole,

make an indentation with a centerpunch and ham-

mer at the point to be drilled. Place the point of the

bit in the indentation and start drilling.

Use a cutting lubricant when drilling metals. The

exceptions are iron and brass which should be

drilled dry.

CAUTION:

• Pressing excessively on the machine will not speed

up the drilling. In fact, this excessive pressure will

only serve to damage the tip of your bit, decrease

the machine performance and shorten the service

life of the machine.

• There is a tremendous force exerted on the

machine/bit at the time of hole breakthrough. Hold

the machine firmly and exert care when the bit

begins to break through the workpiece.

• A stuck bit can be removed simply by setting the

reversing switch to reverse rotation in order to back

out. However, the machine may back out abruptly if

you do not hold it firmly. (Model 6013BR only)

• Always secure small workpieces in a vise or similar

hold-down device.

MAINTENANCE

CAUTION:

Always be sure that the machine is switched off and

unplugged before carrying out any work on the

machine.

Replacement of carbon brushes (Fig. 6 & 7)

Replace carbon brushes when they are worn down to

the limit mark. Both identical carbon brushes should

be replaced at the same time.

To maintain product safety and reliability, repairs,

maintenance or adjustment should be carried out by

Makita Authorized Service Center.