Makita 6013B Руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сверло Makita 6013B. Makita 6013B 6 страниц. 13 mm (1/2")
Также для Makita 6013B: Руководство по эксплуатации (8 страниц), Руководство по эксплуатации (8 страниц), Руководство по эксплуатации (20 страниц)
Печатать страницу
Model 6013BR (Fig. 5)
The switch is reversible, providing either clockwise or
counterclockwise rotation. To start the machine, sim-
ply pull the lower part of the switch for clockwise, the
upper part for counterclockwise. Release the switch
to stop.
Drilling operation
• Drilling in wood
When drilling in wood, best results are obtained with
wood drills equipped with a guide screw. The guide
screw makes drilling easier by pulling the bit into the
workpiece.
• Drilling in metal
To prevent the bit from slipping when starting a hole,
make an indentation with a centerpunch and ham-
mer at the point to be drilled. Place the point of the
bit in the indentation and start drilling.
Use a cutting lubricant when drilling metals. The
exceptions are iron and brass which should be
drilled dry.
CAUTION:
• Pressing excessively on the machine will not speed
up the drilling. In fact, this excessive pressure will
only serve to damage the tip of your bit, decrease
the machine performance and shorten the service
life of the machine.
• There is a tremendous force exerted on the
machine/bit at the time of hole breakthrough. Hold
the machine firmly and exert care when the bit
begins to break through the workpiece.
• A stuck bit can be removed simply by setting the
reversing switch to reverse rotation in order to back
out. However, the machine may back out abruptly if
you do not hold it firmly. (Model 6013BR only)
• Always secure small workpieces in a vise or similar
hold-down device.
4
MAINTENANCE
CAUTION:
Always be sure that the machine is switched off and
unplugged before carrying out any work on the
machine.
Replacement of carbon brushes (Fig. 6 & 7)
Replace carbon brushes when they are worn down to
the limit mark. Both identical carbon brushes should
be replaced at the same time.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
Makita Authorized Service Center.