Alico Optima BR58 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Bezprzewodowy punkt dostępowy Alico Optima BR58. Alico Optima BR58 14 stron. Wireless network equipment optima series
Również dla Alico Optima BR58: Instrukcja obsługi (12 strony)

Drukuj stronę
WNE Wiring Diagram
The wireless network equipment is powered by a 48 VDC Power over Ethernet power supply/injector
module. The following steps should be accomplished to power the WNE:
1.
Install the WNE enclosure either on a pole or to a wall.
2.
Follow the instructions in the next section to assemble the Ethernet weatherproof cable feed
through assembly.
3.
Connect one end of a patch (straight through) CAT 5e Ethernet cable to the AP24/58 through
the Feed through assembly.
4.
Connect the other end of the CAT5e cable to the power and data port of the Power Over
Ethernet Module.
5.
Locate the LAN Switch in your wiring closet and connect a patch (straight through) CAT 5e
cable from the IN/DATA port of the Power over Ethernet module to a LAN Switch port.
6.
Last connect the 48VDC power supply to the Power Over Ethernet injector. Using the
supplied AC power cord connect the power supply to the AC. The unit operates on 110/240
VAC, 50/60 Hz.
Figure 1 Connection Diagram
4