ALIEN ENCLOSURES 67-69 FIREBIRD CONVERTIBLE TRUNK PANEL KIT Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria samochodowe ALIEN ENCLOSURES 67-69 FIREBIRD CONVERTIBLE TRUNK PANEL KIT. ALIEN ENCLOSURES 67-69 FIREBIRD CONVERTIBLE TRUNK PANEL KIT 9 stron.
Drukuj stronęUPHOLSTERY TIPS:
1. Test fit your pieces first to check for trimming (DO NOT ADHERE HOOK & LOOP AT
THIS TIME)
2. It may be necessary to place shims or rubber feet under floor braces to ensure a
firm fit of panel A
3. If you are covering with a thick material, you may need to trim the bottoms of the
panels – check first
4. Remove attached support blocks before covering
5. Check the penetration of your staples on a test piece of material – we suggest ¼" or
shorter - preferably 5/32" (available online)
6. We might suggest using a professional strength hot-glue or wood glue when re-at
taching bracing blocks. You may also want to consider staples as well.
7. We strongly suggest stapling the hook & loop in several spaces on each side of
each tape to prevent the release of the tape
8. You may want to consider using smaller pieces of hook & loop on the side panels for
easier release.
These panels can be somewhat difficult to remove when completely adhered.
9. When removing side panels place one hand on the top of the panel – and another at
he bottom – rock the panel bottom out first (reverse of install). You may want to
use a paint key to grasp the bottom of the panel to pull outward.
10. We suggest using a foam backed vinyl (thin – 1/4" or less). It tends
to keep the vinyl tight and can hide imperfections. However, our first kit did not
have it. If you decide not to use the foam, we suggest spraying your material with
spray adhesive prior to stretching over panels to prevent sag
11. You may want to reinforce the backer panels to the main panels with hot glue in ad
dition to the 7/16" screws with small beads approx 6" apart.
67-69 f body convertible
Trunk Panel Kit Instructions