A+ Corporation, LLC. Genie Direct Drive 752 Instrukcja instalacji i obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Sprzęt testowy A+ Corporation, LLC. Genie Direct Drive 752. A+ Corporation, LLC. Genie Direct Drive 752 5 stron.

Drukuj stronę

An ISO 9001:2008 certiﬁed company

Removing Probe for Service

Step 1. Retract the probe

Retract the probe by using the 7/16" open end wrench only on the wrench flats of the threaded probe.

}

Turn the threaded probe until it comes to a noticeable stop in its original position. (See Figure 2)

}

Step 2. Isolate and Vent the Probe

Slowly close the ball valve to the process. If resistance is meet when closing the valve be sure the probe is retracted 100%.

}

Note: If the probe is closed in the ball valve, the threads on the probe could be damaged.

Use the factory supplied vent valve in the 1/8" NPT auxiliary port and a 7/16" wrench to bleed remaining process that is trapped between the

}

closed process valve and the probe body. (see Figure 1)

Step 3. Remove from process valve

Remove the probe from the process valve using a 1-3/8" open end wrench ONLY on the lowest wrench flats on the base, nearest to the NPT

}

male threads (see Figure 1)

Figure 1

Figure 2

Vent

Valve

Figure 3

Figure 4

Figure 5

SCC-752-InsInstallationOperation_0514