Brother 2340CV Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyna do szycia Brother 2340CV. Brother 2340CV 40 stron. User manual - french and nederlands
Również dla Brother 2340CV: Instrukcja serwisowa (16 strony), (francuski) Manuel D'instructions (41 strony)

Drukuj stronę

Powering the machine

NOTE: (For U.S.A. only)

This foot controller can be used for sewing machine

model 2340CV.

Turning direction of motor

Opening and closing the front cover

How to attach and remove the presser foot

CAUTION

Always be sure to turn off the power before

carrying out this operation.

Preparation

•

Insert the three-pin plug into the socket on the bottom

right side of the machine. Insert the power supply plug

into a power outlet.

Main Power and Sewing Light Switch

This switch turns the power and sewing light on or off. To turn

on push toward " – " mark. To turn off push toward "

1 Main Power and Sewing Light Switch

Operation

When the pedal is pressed lightly, the machine runs at a

low speed. As the pedal is pressed further, the machine

will increase speed. When the pedal is released, the

machine stops.

2 Foot Controller: Model N

•

The motor and hand wheel of this machine turn in a

counterclockwise direction (direction of arrow). This is

the same direction as an ordinary home sewing ma-

chine.

1 Hand wheel

It is necessary to open the front cover when threading this

machine.

•

Open the front cover by sliding it to the right and

guiding the top toward you.

NOTE:

For your safety, make sure that the front cover is closed

when operating the machine.

•

Turn off the main power switch or disconnect the

electric supply plug.

(1) Raise the presser foot lever. 1

(2) Set the needle to its highest position by turning the

hand wheel 2 counter clockwise.

(3) Push the button on the presser foot holder and the

standard foot will be released. 3 4

(4) Raise the presser foot farther by pushing the presser

foot lever upward. Then remove the presser foot and

store it in a safe location.

(5) Again, raise the presser foot farther by pushing the

presser foot lever upward. Then place a presser foot

just under the presser foot holder A so that the

groove in the bottom of the presser foot holder B is

aligned and catches the bar on the top of the foot C.

Then lower the presser foot lever to attach the foot.

" mark.