Brother 2340CV Manuale operativo - Pagina 6
Sfoglia online o scarica il pdf Manuale operativo per Macchina da cucire Brother 2340CV. Brother 2340CV 40. User manual - french and nederlands
Anche per Brother 2340CV: Manuale di servizio (16 pagine), (Francese) Manuel D'istruzioni (41 pagine)
Stampa la pagina
Powering the machine
1
NOTE: (For U.S.A. only)
This foot controller can be used for sewing machine
model 2340CV.
Turning direction of motor
Opening and closing the front cover
How to attach and remove the presser foot
4
1
2
A
B
4
C
CAUTION
Always be sure to turn off the power before
carrying out this operation.
4
2
1
1
2
3
Preparation
•
Insert the three-pin plug into the socket on the bottom
right side of the machine. Insert the power supply plug
into a power outlet.
Main Power and Sewing Light Switch
This switch turns the power and sewing light on or off. To turn
on push toward " – " mark. To turn off push toward "
1 Main Power and Sewing Light Switch
Operation
When the pedal is pressed lightly, the machine runs at a
low speed. As the pedal is pressed further, the machine
will increase speed. When the pedal is released, the
machine stops.
2 Foot Controller: Model N
•
The motor and hand wheel of this machine turn in a
counterclockwise direction (direction of arrow). This is
the same direction as an ordinary home sewing ma-
chine.
1 Hand wheel
It is necessary to open the front cover when threading this
machine.
•
Open the front cover by sliding it to the right and
guiding the top toward you.
NOTE:
For your safety, make sure that the front cover is closed
when operating the machine.
•
Turn off the main power switch or disconnect the
electric supply plug.
(1) Raise the presser foot lever. 1
(2) Set the needle to its highest position by turning the
hand wheel 2 counter clockwise.
(3) Push the button on the presser foot holder and the
standard foot will be released. 3 4
(4) Raise the presser foot farther by pushing the presser
foot lever upward. Then remove the presser foot and
store it in a safe location.
(5) Again, raise the presser foot farther by pushing the
presser foot lever upward. Then place a presser foot
just under the presser foot holder A so that the
groove in the bottom of the presser foot holder B is
aligned and catches the bar on the top of the foot C.
Then lower the presser foot lever to attach the foot.
" mark.