Garmin MSC 10 Instrukcja instalacji
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Morski system GPS Garmin MSC 10. Garmin MSC 10 14 stron. Marine satellite compass
Drukuj stronę
MSC 10 MARINE SATELLITE COMPASS
Important Safety Information
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
For the best performance and to avoid damage to your boat, read all installation instructions before
proceeding. Install the device according to these instructions. Use the appropriate fasteners, tools, and mounts
listed, which are available at most marine dealers.
The MSC 10 satellite compass provides heading information to your existing NMEA 2000
does not have a NMEA 2000 network, you must install one. For more information, go to
/nmea_2000.
Tools Needed
• Drill
3
• 19 mm (
/
in.) drill bit for a pole-mount cable-hole
4
3
• 5 mm (
/
in.) drill bit for surface-mount screw holes
16
• 25 mm (1 in. ) hole saw for a surface-mount cable-hole
• #2 Phillips screwdriver
3
• 35 mm (1
/
in.) wrench
8
• Marine sealant
• Torque wrench
9
• 7 mm (
/
) socket for torque wrench
32
• Additional NMEA 2000 network components as needed
April 2021
INSTALLATION INSTRUCTIONS
CAUTION
NOTICE
GUID-C15E42C9-BE5D-467E-80CA-4DB7F6A31142 v2
network. If your boat
®
garmin.com/manuals