Garmin MSC 10 Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Morski system GPS Garmin MSC 10. Garmin MSC 10 14 stron. Marine satellite compass

Mounting the Compass with the Cable Routed Through the Pole

1 If necessary, attach the stainless steel pole to the boat:

1.1 Position the pole in the selected location, and mark the approximate center of the pole.

1.2 Drill a hole using a 19 mm (

1.3 Fasten the pole to the boat.

2 Screw the included metal nut

3 Route the cable

through the pole, through the pole-mount adapter, and connect it to the compass

4 Place the compass on the pole-mount adapter, and fasten the included M4 screws

5 Screw the pole-mount adapter onto the pole, but do not fully tighten it.

6 Apply the included adhesive around the threads of the pole.

7 Align the compass so it is pointed in the same direction as the boat.

NOTE: You can use the sights on the top of the compass to help align it.

8 While holding the compass steady, finger tighten the nut.

9 Using a 35 mm (1

10 After the compass is secured on the pole mount, fill the vertical cable slot with a marine sealant (optional).

11 Wipe off any excess adhesive or marine sealant.

12 Route the cable away from sources of electronic interference.

in.) drill bit for the cable to pass through.

onto the threaded pole as close to the base as possible.

in.) wrench, turn the nut

turn to secure it.

to secure it.