Garmin MSC 10 Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Morski system GPS Garmin MSC 10. Garmin MSC 10 14 stron. Marine satellite compass

When the heading data appears, the compass has been calibrated successfully, and you can align the

heading (optional).

8 Select an option.

• If you want to align the heading to match the front of the boat, proceed to the next step.

• If you do not want to align the heading, stop turning and wait, keeping the boat stationary. Over the next

two minutes the heading data should disappear and then reappear. When the heading data reappears, the

compass should be calibrated and no heading offset should be applied.

NOTE: If an unwanted heading offset is applied, repeat the calibration procedure.

9 Continue turning in the same direction at the same speed for approximately ten seconds, until the heading

data disappears from the display

10 When it is safe, straighten the boat and drive in a straight line

6.4 km/h (4 mph)) until the heading data appears

When the heading appears, the compass has been calibrated, and the heading has been aligned.

11 Test the results of the calibration, and repeat this procedure if necessary.

Compass Settings

From the NMEA 2000 device list, select the MSC 10, and select Review.

Auto Locate: Allows you to clear existing satellite data and force the device to acquire new data.

Factory Defaults: Allows you to reset the antenna settings to the factory default value. You will lose all custom

configuration settings.

Avoid chemical cleaners and solvents that can damage plastic components.

1 Clean the outer casing of the device using a cloth dampened with a mild detergent solution.

2 Wipe the device dry.

Appendix

You must update the Garmin chartplotter software when you install this device. For instructions on updating

the software, see your chartplotter owner's manual at support.garmin.com.

NOTICE

at cruising speed (must be at least