Garmin FUSION APOLLO MS-WB675 Instrukcja instalacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyposażenie morskie Garmin FUSION APOLLO MS-WB675. Garmin FUSION APOLLO MS-WB675 19 stron. Marine entertainment system
Również dla Garmin FUSION APOLLO MS-WB675: Podręcznik (46 strony)
Drukuj stronę
Connecting to Power Through an Ignition Switch
This method of connection is used most often on ski boats, wake boats, and similar sport or recreational
vessels where power to the engines is toggled often. For these installations, a quick standby and faster startup
time is desired so that music can be stopped and begin playing again as quickly as possible after restarting the
engines. When in standby mode, the stereo uses up to 200 mA, and you should connect the power wires through
a circuit breaker or manual switch to avoid draining the battery when you are not using the boat.
1 Consult this diagram to plan the wire connections.
Item Description
Yellow wire
Red wire
1 A fuse (not included)
Ignition or ACC switch
Black wire
15 A fuse (not
included)
15 A circuit breaker or
manual switch
2 Route all wires to the stereo wiring harness, the ignition or ACC switch, the circuit breaker, and the power
source as necessary.
Do not connect the wiring harness to the stereo until after you have made all of the bare wire connections.
3 Install all of the necessary fuses on the red and yellow wires.
4 Connect the wiring harness to the stereo.
8
Notes
You must connect this wire to the same power source as the ignition or ACC
switch.
You must connect this wire to the ignition or ACC switch before you connect
it to the same power source as the yellow wire.
You must install this fuse on the red wire before you connect the red wire to
the ignition or ACC switch.
Connecting the red wire to this switch allows the stereo to enter a low-power
standby mode when you turn off the engines, so it can start up faster when
you turn on the engines again.
Ground (-)
This fuse is required if you are not able to connect to power through a 15 A
circuit breaker
.
If a circuit breaker is not available, you must connect a 15 A fuse
the yellow wire. You should also connect the yellow wire to power using a
manual switch, so you can remove power to the stereo when you are not
using the boat.
on