Garmin FUSION APOLLO MS-WB675 Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyposażenie morskie Garmin FUSION APOLLO MS-WB675. Garmin FUSION APOLLO MS-WB675 19 stron. Marine entertainment system
Również dla Garmin FUSION APOLLO MS-WB675: Podręcznik (46 strony)

Garmin FUSION APOLLO MS-WB675 Instrukcja instalacji
When you turn on the ignition switch, the stereo turns on along with other accessory electronics. When you turn
off the ignition switch, the stereo enters a low-power standby mode.
NOTE: When you are not using the vessel for an extended period of time, you should remove power to the stereo
using the circuit breaker or other manual switch on the yellow wire to avoid draining the battery.

Speaker Zones

You can group speakers in one area into a speaker zone. This enables you to control the audio level of the
zones individually. For example, you could make the audio quieter in the cabin and louder on deck.
Up to two pairs of speakers can be connected per channel of each zone, in parallel. One zone can support no
more than four speakers using the on-board amplifier (zones 1 and 2).
Zones 1 and 2 are powered by the on-board amplifier. Zones 3 and 4 are available as a line-level output only.
To use the RCA line output and the RCA subwoofer output for zones 3 and 4, you must connect an external
amplifier.
You can set the balance, volume limit, tone, subwoofer level, subwoofer frequency, and name for each zone, and
configure other zone-specific settings.
Single-Zone System Wiring Example
Speakers
Water-tight connection
9