Garmin GSD 26 Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyposażenie morskie Garmin GSD 26. Garmin GSD 26 6 stron. Professional sonar module
Również dla Garmin GSD 26: Instrukcja instalacji (6 strony), Instrukcja instalacji (14 strony)

Drukuj stronę

Replace and secure the terminal block lid on the sounder

with a #2 Phillips screwdriver.

NOTE: The sounder does not operate when the lid is

removed.

Grounding the Sounder

The chassis ground post is located on the exterior of the

chassis, adjacent to a corner mounting hole.

Connect the chassis ground post to the boat water ground

circuit.

Mount the sounder

(Mounting the

power, marine network, transducer, and sensors

the

Sounder) .

Installing Locking Rings on the Cables

Before you install locking rings on the cables, you must route

the cables.

To help make the cable-routing process easier, the locking rings

are packaged separately from the cables. Each locking ring is

packaged in a small bag with a number on the label for easy

identification.

Separate the two halves of the locking ring

Align the two halves

snap them together.

Insert the o-ring

into the end of the connector.

Transducer Wiring Diagrams

Connecting the high-frequency wires to the low-frequency

terminal block, or the low-frequency wires to the high-frequency

terminal block, damages the device and the transducer.

You can use these diagrams to identify the connection points for

your transducer wires on the GSD 26 terminal block. Locate

your CHIRP/spread spectrum transducer model in the wiring

Sounder) and connect the

(Connecting

of the locking ring over the cable and

NOTICE

color tables

(Transducer Wire Color

information.

The outer shield wire must connect to one of the two screw

posts below the terminal block using the included ring crimp

terminal. When connecting two single-element transducers, you

must connect the second transducer to the duplicate set of

connections on the right side of the terminal block.

TIP: The primary transducer cable wire housing covers the

wiring bundles. To identify the wiring groups in the bundles more

easily, you can remove up to an inch of the cable housing.

Single-Element CHIRP/Spread Spectrum

Dual-Element CHIRP/Spread Spectrum with

Temperature and XID

NOTE: The temperature and XID wires can be connected at

either location.

Dual-Element CHIRP/Spread Spectrum with XID

NOTE: The XID wires can be connected at either location.

Dual-Element CHIRP/Spread Spectrum with Separate

Temperature Sensor

NOTE: The temperature and XID wires can be connected at

either location.

Tables) for more